.The series Impact crusher (Crusher) is my company in the absorption of foreign advanced technology, combined with sand and gravel mining industry specific conditions and the development of the latest generation Impact crusher. It uses the latest manufacturing technology, the unique structural design, processing and end product was a cube, no tension and cracks, grain shape is very good, can crusher feed size less than 500mm, compression strength not more than 350MPa of various coarse, medium and fine materials (granite, limestone, concrete, etc.), widely used in ore crushing, railway, highway, energy, cement, chemical, construction and other industries.Its output size can be adjusted, broken specifications diversification. 
The series Impact crusher can handle side length of 100 to 500 mm below the material, the compressive strength up to 350 MPa, with a crushing ratio, cubic particles were broken materials, etc., suitable for crushing medium hard materials, such as cement limestone crushing, has a large capacity, a small particle size advantages.

1, a large inlet, high crushing chamber to meet the material hardness, block degree, the product powder less. 
2, the back plate and the board hammer gap can be easily adjusted, effective control of the particle size, particle shape is good. 
3, compact, rigid machine, the rotor has a large moment of inertia. 
4, high chrome plate hammer, impact resistance, abrasion resistance, impact force. 
5, keyless access, easy maintenance, economical and reliable. 
6, crushing full-featured, high productivity, little mechanical wear, high overall efficiency.

Impact crusher is a use of impact energy to crush materials broken machinery. The machine work, driven by the motor, the rotor rotating at high speed, the material into plate hammer area of ​​the rotor plate hammer impact crusher, then was thrown back on the device again broken, and then from the back liner bounced back plate hammer area re-broken, this process is repeated, the material descending into one, two, three, back cavity repeated broken until the material is crushed to the desired particle size by the discharge port. Adjust back frame and the gap between the rotor material can achieve the change the shape of the particle size and material purposes.